Grizzly G0853 Owner's Manual page 37

35. Slowly roll crosscut fence face up, and guide
T-bolts aligned in Steps 32c & 33b into their
respective hole/slot.
36. From underneath left side of crosscut fence,
thread pivot lock knob into T-bolt in pivot
hole, as shown in Figure 44.
37. From underneath middle of crosscut fence,
position M8-1.25 T-slot plate in angle scale
bar slot, then thread angle scale bar lock
knob and 8mm fender washer onto T-slot
bolt, as shown in Figure 44.
38. On right side of crosscut fence, ensure 0°
stop block is up against stop bolt (see Figure
44), then rotate latch into catch and secure by
tightening knurled thumb knob.
Note: The stop bolt is set at the factory and
does not need to be adjusted.
Pivot Lock
Knob
Angle Scale
Lock Knob
Figure 44. Crosscut fence secured to table.
Model G0853 (Mfd. Since 07/18)
Thumb Knob
39. Slide out crosscut fence extension approxi-
mately 6", as shown in Figure 45.
40. Insert (2) flip stops into T-slot on fence and
tighten knob bolts to secure (see Figure 45).
Knob Bolt
Fence
Extension
Figure 45. Flip stops installed on crosscut fence.
41. Locate T-bolt at end of crosscut fence exten-
sion and install fence clamp assembly, as
shown in Figure 46.
T-bolt
Crosscut
Fence
Figure 46. Installing clamp assembly on crosscut
fence extension.
Flip Stop
(1 of 2)
Fence
Extension
-35-