Grizzly G0853 Owner's Manual page 39

49. Loosen pre-installed hex bolt shown in Figure
51, and slide middle guard arm into middle
guard arm post. Hand-tighten hex bolt for
now.
Hex Bolt
Upper Guard
Arm Post
Figure 51. Installing middle guard arm in middle
guard arm post.
50. Remove (2) pre-installed button head cap
screws, lock washers, and flat washers from
4" dust port, and install dust port in end of
middle guard arm (see Figure 52).
4" Dust Port
Figure 52. Installing 4" dust port in middle guard
arm.
Model G0853 (Mfd. Since 07/18)
Middle Guard Arm
x 2
51. Use (3) M6-1 x 20 cap screws, 6mm lock
washers, and 6mm flat washers to attach
blade guard cover to middle guard arm (see
Figure 53).
Blade Guard
Cover
x 3
Figure 53. Blade guard cover attached to middle
guard arm.
52. Use (2) M6-1 x 12 button head cap screws
and 6mm lock washers to attach 3" dust port
to middle guard arm (see Figure 54).
Figure 54. Installing 3" dust port on middle
guard arm.
x 2
3" Dust Port
-37-