Grizzly G0853 Owner's Manual page 42

60. Insert arbor locking pin into access hole
shown in Figure 62.
Note: Main blade is shown here only for illus-
trative purposes.
61. Push down on locking pin with one hand (see
Figure 62) as you rotate arbor nut clockwise
with wrench. This will force blade locking
pin into arbor indent and prevent arbor from
rotating in next steps.
Figure 62. Loosening main blade arbor bolt.
62. Continue unthreading arbor nut clockwise (it
has left-hand threads) until you can remove
flange (see Figure 63).
Arbor Nut
Flange
Figure 63. Main blade arbor parts and tools for
changing blade.
Before proceeding with the next steps, wear
gloves to protect your hands when handling
and installing the blade.
-40-
Arbor
Locking Pin
Arbor Nut
Wrench
Arbor Locking Pin
63. Slide main blade (not included) over arbor
with teeth facing to the right, then install
flange (see Figure 64).
Upper Teeth
Facing Right
Flange
Arbor
Nut
Figure 64. Main blade component assembly.
64. Thread arbor nut on counterclockwise and
fully tighten it to secure the blade (see
Figure 65).
Figure 65. Main blade installed on arbor.
65. Install and align riving knife (refer to Riving
Knife Alignment beginning on Page 49 for
detailed information).
66. Close blade cover. Center sliding table and
lock in place.
Model G0853 (Mfd. Since 07/18)
Arbor