Operation On 220/240 Volts.7; Word Of Caution.7; Assembly Section.7 - Grizzly G1538 Instruction Manual

7
C. OPERATION ON 220/240 VOLTS
Normally, there is not any need to operate this machine on 220/240V. However, you can if you
desire to do so. There are a few things that have to be done in order to accomplish this.
First of all, the 110V/120V plug must be removed from the cord. Secondly, the wires under the
motor cover must be switched to operate on 220V/240V. Refer to the diagram inside on the lid.
Lastly, you must replace the magnetic switch with one that operates on 220/240V and 2 HP. For
your convenience we have detailed two outlet plug configurations that are of the grounding type
and safe to use (see Figure 1). The NEMA Style numbers are given for your reference regardless
of brand purchased.
Figure 1 Shows electrical plug configuration.
Normal ly, on the higher voltage, the use of "slo-blow" fusing is not necessary because the current
is much lower. A standard 2-pole, 15 ampere fuse or circuit breaker hook-up will work just fine
here.
If it is necessary to use an extension cord, use one with #12 copper conductors or larger. Use
NEMA approved couplers only and be rated for hard service, SJO, and contain a ground wire.
D. WORD OF CAUTION
NEVER cut off the ground pin from the plug. Should you choose to cut off the plug and use another
style, make sure the type selected is suitable for use as an equipment grounding method, as not all
kinds are. We have recommended electrical service requirements on how to "WIREUP" your 16"
Bandsaw. This is by no means the last word on how to accomplish this. Many states, counties,
cities, towns, etc., have their own electrical codes that must be complied with. If you have any
doubts as to the correct electrical requirements, you may need for your application, consult with
your local authorities, the national electrical code, and/or licensed electrician. If you have
problems with the electrical system that we provide with this unit, call our service department.
VIII. ASSEMBLY SECTION
Since the main Bandsaw unit is preassembled at the factory, the rest of the parts to be assembled
are relatively few and easy to attend to. In any event, we will assist you in your endeavor, to make it
as easy and smooth as possible. The tools required for assembly are:
5mm Allen Wrench
12mm Open End Wrench
Adjustable Wrench
Phillips and Regular Screwdrivers
Dead Blow or Brass Hammer