Grizzly G0853 Owner's Manual page 70

6. Position blade guard according to height
of workpiece. (Refer to Understanding &
Using Blade Guard on Page 48.)
7. Load workpiece onto table saw. The setup
should look similar to Figure 130 on Page 67.
8.
Take all necessary safety precautions, con-
nect saw to power, then perform cutting
operation.
Rip Cutting with Rip Fence
Rip Cutting with Rip Fence
1.
DISCONNECT MACHINE FROM POWER!
2.
Move crosscut table and fence to front of slid-
ing table, and lock them in place with cross-
cut table lock lever (see Figure 134).
Crosscut Table
Lock Lever
Figure 134. Location of crosscut table lock lever.
3.
Lock sliding table in place with table lock
lever (see Figure 135).
Figure 135. Location of sliding table lock lever.
-68-
Sliding Table
Lock Lever
4. Loosen rip fence lock lever, as shown in
Figure 136.
Figure 136. Location of rip fence lock lever.
5. Place fence in vertical position (see Figure
137) for thicker workpieces, or in horizontal
position for thinner workpieces and for angled
cuts where blade is tilted over the fence.
Vertical
Horizontal
Figure 137. Rip fence positions.
Model G0853 (Mfd. Since 07/18)
Rip Fence
Lock Lever