Grizzly G0853 Owner's Manual page 31

4. Remove access covers to reach mounting
holes for sliding table (see Figures 22–23).
Reach through cabinet access hole to reach
middle mounting hole (see Figure 24).
5.
Use (5) M12-1.75 x 50 hex bolts, 12mm lock
washers, and 12mm spacers to secure slid-
ing table to machine frame (see Figures
22–24).
x 2
Figure 22. Mounting hole access on rear side at
front of saw.
x 2
Figure 23. Mounting hole access on rear side at
back of saw.
Figure 24. Middle mounting hole access through
cabinet access hole.
Model G0853 (Mfd. Since 07/18)
6. Slide push handle onto mounting rod at front
end of sliding table, as shown in Figure 25,
and secure with knob.
Push Handle
Knob
Figure 25. Push handle attached to sliding table.
7.
Attach cabinet door by sliding hinge sleeves
over pins on pre-installed hinges (see Figure
26).
Hinge Sleeves
& Pins
Figure 26. Cabinet door attached to hinges.
-29-