Grizzly G0853 Owner's Manual page 62

3. Lift fence off table and roll it gently onto
its side so T-bolts (see Figures 111–112)
remain in same position.
Rear Pivot Hole
T-Bolt
Front Pivot Hole
Figure 111. Location of front and rear pivot
holes and pivot knob T-bolt.
T-Bolt
Figure 112. Location of angle scale bar and
T-bolt.
4.
Move fence to front or rear position, and
insert T-bolt into front hole or rear pivot hole,
and insert angle scale bar T-bolt into angle
scale bar slot.
5.
Rotate fence so 0° stop block is up against
stop bolt (see Figure 113), then rotate latch
into catch and secure by tightening knurled
thumb knob.
-60-
6.
Angle
Scale Bar
Positioning Crosscut Table Along
Sliding Table
The crosscut table can be positioned as neces-
sary along the sliding table (see Figure 115).
Latch 0° Stop Block
Catch
Figure 113. Stop block against 0° stop bolt.
Loosen support bar knob bolt shown in
Figure 114, slide support bar into position
required for operation, then tighten knob bolt.
Knob Bolt
Support Bar
Figure 114. Location of knob bolt for adjusting
support bar position.
Figure 115. Crosscut table positions along
sliding table.
Model G0853 (Mfd. Since 07/18)
Stop Bolt