Grizzly G0853 Owner's Manual page 32

8. Install (3) M10-1.5 x 20 set screws and (3)
M10-1.5 hex nuts on large extension table
(see Figure 27). Only hand-tighten screws
for now.
9. Attach large extension table to cast-iron table
using (3) pre-installed M10-1.5 x 25 cap
screws, 10mm lock washers, and 10mm flat
washers (see Figure 27). Only hand-tighten
cap screws for now. They will be fully tight-
ened in a later step.
Hex Nut
x 3
Figure 27. Location of fasteners used to install
and level large extension table.
10. Place a straightedge across cast-iron table
and large extension table to see if tables are
parallel.
— If entire length of straight edge is parallel
with both tables, proceed to Step 11.
— If both tables are not parallel with straight
edge, loosen hex nuts on set screws
shown in Figure 27. Adjust set screws to
align top of extension table with top of cast
iron table, then retighten hex nuts to secure
setting.
11. Fully tighten cap screws from Step 9.
-30-
x 3
Set Screw
12. Attach leg (see Figure 28) to large extension
table using (2) pre-installed cap screws, lock
washers, and flat washers.
13. Loosen hex nut on foot (see Figure 28),
adjust height of foot to maintain parallel-
ism of extension table and cast-iron table,
then tighten hex nut against bottom of leg to
secure.
Leg
Figure 28. Leg attached to large extension table.
14. Install (3) M10-1.5 x 20 set screws and (3)
M10-1.5 hex nuts on small extension table
(see Figure 29). Only hand-tighten screws
for now.
15. Attach small extension table to cast-iron
table using (3) pre-installed M10-1.5 x 25 cap
screws, 10mm lock washers, and 10mm flat
washers (see Figure 29). Only hand-tighten
cap screws for now. They will be fully tight-
ened in a later step.
Hex Nut
Figure 29. Location of fasteners used to install
and level small extension table.
Model G0853 (Mfd. Since 07/18)
x 2
Foot
x 3
Set Screw
x 3