Grizzly G0853 Owner's Manual page 9

Overhead Control Panel (Upper)
T
T. Digital Display Screen. Displays information
about rip fence positions and operations.
U. F1 Key. Press to return to main screen.
V. Tool-Box Key. Press to record width and
diameter of main blade in database.
W. CAL Key. Press to calibrate distance between
rip fence and main blade.
X. Math Function Keys. Use to perform math-
ematical functions on measurement currently
shown in digital display.
Y. Numeric Keypad. Use to enter measure-
ments in digital display.
Z. CE Key. Clears typed entries in digital display.
AA. M– Key. Decreases distance between blade
and rip fence in increments of 0.01" (0.1mm).
AB. M+ Key. Increases distance between blade
and rip fence in increments of 0.01" (0.1mm).
Model G0853 (Mfd. Since 07/18)
Figure 6. Overhead control panel functions (upper).
U V W
AJ
AI
AH
AG
AF AE AD
AC. STOP Key. Stops rip fence operation in
progress.
AD. START Key. Press to begin rip fence opera-
tion. Key will remain illuminated until opera-
tion is complete.
AE. PROG Key. Press to record rip fence settings.
AF. F2–F5 Keys. Perform a variety of second-
ary functions when used in combination with
other function keys.
AG. Dimension Repeat Key. Press to access
and repeat last two positions of the rip fence.
AH. Incremental Dimension Key. Press to enter
measurements for making repeat cuts.
AI. Grooves/Concealed Cuts Function Key.
Press to enter rip fence measurements for
performing non-through cuts.
AJ. mm/inch Selection Key. Press once to
toggle between inch and metric units.
X Y
AC AB AA
Z
-7-