Grizzly G0853 Owner's Manual page 89

Lube Trunnions
Trunnions
Lubrication Type ... T26419 or NLGI#2 Equivalent
Amount ..................................................1-2 Dabs
Lubrication Frequency .....................6–12 Months
To grease the blade-tilt trunnions (see Figure 178),
move the sliding table out of the way, open the
blade guard, then tilt the blade to 0°. From the
front of the saw, smear a dab of grease in the
front of the trunnion grooves on both sides. Now,
tilt the blade to 45° and reach inside the cabinet
and smear a dab of grease into the back of the
trunnion grooves on both sides. Tilt the blade
through its full range of movement to spread the
grease.
Trunnions
Figure 178. Trunnion lubrication locations (table
removed for clarity).
Model G0853 (Mfd. Since 07/18)
Lube Rip Fence Leadscrew
Rip Fence Leadscrew
Lubrication Type ... T26419 or NLGI#2 Equivalent
Amount ..........................................................Dab
Lubrication Frequency .....................6–12 Months
Clean the threads of the rip fence leadscrew (see
Figure 179) with a stiff brush and mineral spirits.
When dry, add lubricant to the grease fitting, and
move the rip fence back and forth a few times to
distribute the grease.
Leadscrew
Figure 179. Grease fitting for rip fence
leadscrew.
Grease
Fitting
-87-