Omron CJ Series Operation Manual page 57

Flat Connectors
In a CompoNet Network, the connectors described below can be connected to the Communications
Cable to enable extending the cable length, branching cables, and wiring to Slave Units.
Flat Connector Socket
• Flat Cable I
Name
Flat Connec-
tor Socket
Note The only case when the Socket is used with a Round Cable II is to connect the Cable to a Terminating Resis-
tor.
• Flat Cable II
Name
Flat Connec-
tor Socket
CJ-series CompoNet Master Unit Operation Manual for NJ-series CPU Unit (Cat. No. W493)
Model Appearance
DCN4-TR4 Use this Connector in a set
with a DCN4-BR4 Flat Con-
nector Plug for the following
applications.
• Extending the trunk line or a
• T-branching a branch line
• T-branching a sub-branch
Model Appearance
DCN5-TR4 Use this Connector in a set
with a DCN5-BR4 Flat Con-
nector Plug for the following
applications.
• Extending the trunk line or a
• T-branching a branch line
• T-branching a sub-branch
Note Use the Connector to
Application
sub-trunk line
from the trunk line or a sub-
trunk line
line from a branch line
Application
sub-trunk line
from the trunk line or a sub-
trunk line
line from a branch line
connect IP54 Bit Slave
Units.
1 Introduction
Communications Cables
(Yes: Can be used.
No: Cannot be used.)
Round Round Flat
Cable I Cable II Cable I Cable II
No Yes Yes
(See
note.)
Communications Cables
(Yes: Can be used.
No: Cannot be used.)
Round Round Flat
Cable I Cable II Cable I Cable II
No No No
1
Flat
No
Flat
Yes
1-17