Omron CJ Series Operation Manual page 117

4 Installation and Wiring
Flat Cable II
A DCN5-BR4 Flat Connector Plug is connected to the communications connector on the Master
Unit. Refer to 4-3 Preparing and Mounting Flat Connectors.
Orient the Connector so that the white line on the cable is facing to the left and press in the Connec-
tor until it clicks into place.
4
Note To remove an inserted Connector, hold the latches on both sides, and pull out the Connector.
CJ-series CompoNet Master Unit Operation Manual for NJ-series CPU Unit (Cat. No. W493) 4-9