Omron CJ Series Operation Manual page 123

Flat Cable I
A DCN4-TR4 Flat Connector Socket is mounted at the end of the communications cable. Then a
DCN4-TM4 Terminating Resistor is attached to the Socket.
Flat Connector Socket
• Mounting Procedure
Press the Terminating Resistor into the Socket until it clicks into place.
Note To remove a Terminating Resistor which has been attached, hold the latches on both sides of
the Resistor, and pull it out.
When a Slave Unit or a Repeater Unit has a multidrop connection, the Terminating Resistor can be
directly attached to the Multidrop Connector that is mounted on the Unit. This is only applicable with
Flat Cable I cables.
Terminal Resistor
Slave Unit or
Repeater Unit
Flat Cable II
A DCN5-TR4 Flat Connector Socket is mounted on the communications cable. Then a DCN5-TM4 Ter-
minating Resistor is attached to the Socket.
Flat Connector Socket
• Mounting Procedure
Press the Terminating Resistor into the Socket until it clicks into place.
Note To remove a Terminating Resistor which has been attached, hold the latches on both sides of
the Resistor, and pull it out.
CJ-series CompoNet Master Unit Operation Manual for NJ-series CPU Unit (Cat. No. W493)
Terminating Resistor
Flat Connector Plug
Multidrop Connector
Terminating Resistor
4 Installation and Wiring
4
4-15