Daikin DCM601A51 User Manual page 191

• Ao, Mo Tab (Action Setup Screen)
This screen is displayed when you touch the Ao, Mo tab on the Action Setup screen.
Set up the operation of Ao and Mo.
Select the check box of the items to set up and select/enter the setting using the combo box/
Modify button.
(1) Analog Value setting area
Ao refers to analog signal output.
This function enables the signal output equipment (I/O module) connected to the iTM to output a
current/voltage corresponding to the adjustment value from external equipment.
(It is used for the adjustment of building equipment, such as degree of aperture of a damper/valve.)
The range, incremental width, and unit of the analog values are set on the screen during trial.
(The unit setting may not be available.)
(2) MultiState setting area
It allows you to select and set a MultiState value for Mo.
The MultiState value set on the screen is set up during the trial.
NOTE
You cannot set up MultiState for an area.
(3) OK button
Saves the edit and closes the screen.
(4) Cancel button
Cancels the edit and closes the screen.
NOTE
For information on the setting items and range of values you can set in each tab, see
"Appendix 2. Setup items".
(1)
(2)
User's Manual EM11A015B
intelligent Touch Manager
(3) (4)
190