Outputting Function Settings - Daikin DCM601A51 User Manual

7-3 Outputting Function Settings

The iTM includes various functions, and each of them needs settings. You can save them to a CSV
file using the Setup Export function and use a computer to check the current settings. The following
describes how to output the settings.
See below for settings you can output using this function.
For the USB memory requirements, see "Peripheral Equipment Specifications (CB14A005)."
<Batch settings output details>
Function
Schedule
Interlocking Control
Emergency Stop
Auto Changeover
Temperature Limit
Sliding Temperature
HMO
Setback
Power Proportional
Distribution
1. Touch the Setup Export button on the Operation Mgmt. tab of the Menu List screen (see "4-5
Menu List Screen: Operation Mgmt. Tab").
2. A confirmation dialog with the message "Save CSV-file with batch output settings?" appears.
Connect a USB memory to the iTM unit and touch the Yes button. Outputting to the USB
memory takes up to 2 minutes per 1MB.
3. Output is complete when the message "File has been saved." appears. Touch the Close button
to close the screen.
NOTE
For information on the CSV file format for each function, see "Appendix 5. Setup Export CSV
File Format".
Settings of programs registered with the Schedule Control.
Settings of programs registered with the Interlocking Control.
Settings of programs registered with the Emergency Stop.
Settings of programs registered with the Auto Changeover.
Settings of groups registered with the Temperature Limit.
Settings of groups registered with Sliding Temperature.
Settings of management points registered with HMO.
Recovery temperature and setback temperature settings.
Excluded time settings of the past 13 months.
User's Manual EM11A015B
intelligent Touch Manager
Output content
150