Aligning The Needle Bar Linkage; Moving The Needle Bar Linkage Sideways - Dürkopp Adler M-TYPE H867 Service Manual

Aligning the needle bar linkage

10 Aligning the needle bar linkage
Sequence
First check the following settings:
• A straight and undamaged needle has to be inserted
Correct setting
Upper stitch length adjusting wheel to 0:


10.1 Moving the needle bar linkage sideways

Cover
• Arm cover (
• Head cover (
Figure 32: Aligning the needle bar linkage sideways
(1) - Setscrews
(2) - Adjusting rings
Setting steps
1. Position the upper stitch length adjusting wheel to 0.
2. Loosen the setscrews (1) on the two adjusting rings (2) at the right-hand
Service manual H867 Version 00.0 - 08/2013
(  Betriebsanleitung Kap. 7.3 Nadel einsetzen und wechseln)
The needle pierces exactly in the center of the feed-dog needle hole.
WARNING
Risk of injury
Switch off the sewing machine before aligning the needle bar
linkage sideways.
 Section 4.4.2 Removing and fitting the arm cover,
page 11)
 Section 4.4.3 Removing and fitting the head cover,
page 11)
end of the shaft for the needle bar linkage.
(3) - Needle hole
(4) - Needle bar linkage
41