Working Basis; Symbols In The Text - Dürkopp Adler M-TYPE H867 Service Manual

4 Working basis

4.1 Symbols in the text

The following symbols at the side and in the text show which type of infor-
mation the text contains.
Correct setting
Specifies the correct setting.
Faults
Specifies the faults that can occur due to an incorrect setting.
Cover
Specifies which covers have to be removed in order to access the compo-
nents going to be set.
Steps to be performed for servicing, maintenance, and installation
Steps to be performed via the software control panel
The individual steps are numbered:
1. First setting step
1.
2.
2. Second setting step
3.
3. Third setting step, etc.
...
The sequence of setting steps must always be followed.
Result of performing an operation
If the machine is changed in one particular setting step or a new notifica-

tion text appears in the display which is considered as important feedback
for you, then this change will be identified by an arrow: 
Specifies setting steps for the software via the control panel. The steps are
numbered. The sequence of setting steps must always be followed.
Important
Specifies what you have to be particularly careful about during the work
step.
Information
Provides additional information.
Sequence
Specifies the work to be performed before or after a setting.
Reference

A reference is provided to another place in the text.
8
Working basis
Service manual H867 Version 00.0 - 08/2013