Table of Contents
Advertisement
Working basis
Figure 10: Locking the sewing machine in place
(1) - Locking opening
(2) - Plug
Locking the machine in place
1. Remove the plug (2) from the locking opening (1).
2. Turn the handwheel until the appropriate groove (3) is in front of the
3. Insert the locking peg (3) with the appropriate end into the groove (4).
Removing the locking mechanism
1. Pull the locking peg (3) out of the groove (4).
2. Insert the plug (2) into the locking opening (1).
4.7 Putting the handwheel into position
With some settings, the graduated scale on the handwheel has to be put
into a certain position.
Figure 11: Putting the handwheel into position
Setting steps
1. Turn the handwheel until the specified number on the graduated
Service manual H867 Version 00.0 - 08/2013
1
2
locking opening (2):
• Small groove at handwheel position 0°
• Large groove at handwheel position 200 – 205°
(1) - Graduated scale (2) - Pointer
scale (1) is next to the pointer (2).
(3) - Locking peg
(4) - Groove
4
3
17
Advertisement
Table of Contents
