Table of Contents
Advertisement
Sewing feet
13.4 Setting the sewing foot lifting height
When the pedal is pressed back halfway, the sewing feet can be raised
during sewing, e. g. to move the material being sewn.
When the pedal is pressed completely back, the sewing feet will be raised
after the thread is cut so that the material being sewn can be exchanged.
Correct setting
The distance between the raised sewing feet and the throat plate is preset
to 25 mm on delivery.
Figure 48: Setting the sewing foot lifting height
(1) - Adjusting screw
(2) - Counternut
Setting steps
1. Loosen the counternut (2) for the adjusting screw (1).
2. Turn the adjusting screw (1) to set the distance between the raised sew-
3. Tighten the counternut (2) for the adjusting screw (1).
Service manual H867 Version 00.0 - 08/2013
WARNING
Increased risk of injury
The sewing machine must remain switched on so that the sew-
ing feet can be raised.
Work very carefully when you check and set the lifting height
for the sewing feet.
Do not put your hands under the sewing feet when they are
being lowered.
ing feet and the throat plate:
• To raise the sewing feet to a lesser height: Turn the screw to the
right
• To raise the sewing feet higher: Turn the screw to the left
61
Advertisement
Table of Contents
