Setting The Winder - Dürkopp Adler M-TYPE H867 Service Manual

15.2 Setting the winder

Correct setting
The winder wheel runs smoothly and without axial play.
The winding process will stop automatically when the required filling quan-
tity of the bobbin is reached.
Cover
• Arm cover (
Figure 52: Removing the winder and setting the winder filling quantity
(1) - Winder screws
(2) - Winder flap screw
Setting steps
Removing the winder
1. Loosen the winder screws (1).
2. Remove the winder.
Setting the winder filling quantity
The position of the arms on the winder flap screw (2) determines the filling
quantity:
66
WARNING
Risk of injury
Switch off the sewing machine before setting the winder.
 Section 4.4.2 Removing and fitting the arm cover,
page 11)
• Arms parallel:
Automatic winding stop at 0.5 mm under the edge of the winder
• Arms closer together:
Automatic stop with larger filling quantity
• Arms further apart from each other:
Automatic stop with smaller filling quantity
(3) - Winder flap
(4) - Arms
Service manual H867 Version 00.0 - 08/2013
Winder