Sewing feet
13.1 Setting an even sewing foot stroke
Correct setting
For sewing foot stroke 3, the presser foot and feeding foot are raised by
the same height.
Cover
• Arm cover (
Figure 44: Setting an even sewing foot stroke
Performing the setting steps
1. Set the handwheel to the 0° position.
2. Loosen the screw (3) for the sewing foot lever (4).
3. Lower the presser foot (1) and feeding foot (2) together down to the
4. Tighten the screw (3) for the sewing foot lever (4).
Service manual H867 Version 00.0 - 08/2013
WARNING
Risk of injury
Switch off the sewing machine before checking and setting the
sewing foot stroke.
Section 4.4.2 Removing and fitting the arm cover,
page 11)
(1) - Presser foot
(2) - Feeding foot
throat plate.
Important: Make sure that the feeding foot is only lowered down to the
throat plate. Do not inadvertently lower the feeding foot through the
throat plate cut-out down to the feed-dog.
(3) - Screw
(4) - Sewing foot lever
57