Setting The Handwheel Scale - Dürkopp Adler 967 Service Instructions Manual

Setting the handwheel scale

5
Correct setting
Lock the machine in place at position 2 ( page 19).
 The handwheel must be at position 180°.
Cover
• Removing and refitting the handwheel and drive belt cover
Figure 15: Setting the handwheel scale
(1) - Screws
(2) - Handwheel
Setting steps
1. Removing the drive belt cover and handwheel ( page 13), removing
2. Loosen the screws (1).
3. Fitting the drive belt cover and handwheel.
4. Lock the machine in place at position 2 ( page 19).
5. Set the handwheel (2) to 180° ( page 20).
6. Insert the hexagon wrench through the opening (3) into the set screw,
7. Removing the drive belt cover and handwheel ( page 13).
8. Tighten the screws (1).
9. Fit the ridged drive belt, drive belt cover and handwheel.
Service instructions 967 - 00.0 - 12/2014
Setting the handwheel scale
WARNING
Risk of injury
Crushing injuries from moving parts.
Switch the sewing machine off before you check and set the
position of the handwheel on the arm shaft.
( page 13).
the ridged drive belt ( page 25).
and tighten it.
(3) - Opening for the wrench
23