Connect The Can Cables - Graco HydroShield WABH00 Instructions - Parts Manual

Installation
Connect Connect the Connect the the Fluid Fluid Fluid Supply Supply Hose Supply
Cabinet Cabinet Cabinet
On systems that are not color change enabled:
Use a wrench to connect the fluid supply hose
between the fluid supply and the fluid inlet (F) on the
isolation cabinet. The maximum fluid pressure is 100
psi (0.7 MPa, 7.0 bar).
Note
Do not overtighten as this will rotate the inlet
valve and cause an issue with the flexible
hose on the inside of the cabinet. The valve
outlet on the inside of the cabinet should be
pointed upward.
Note
For the system to function correctly, the inlet
fluid pressure must not exceed the inlet air
pressure.
Consider installing a manual fluid shut-off valve (FV)
close to the cabinet to easily turn off the fluid supply
during installation or service.
On systems that are color change enabled:
Connect the fluid supplies to the inlet color change
valves. Ensure that the air line, flush material, and
dump hose are connected to the correct color change
valves. If the dump valve is not used, plug the fluid
port on the dump valve.
Valve Valve Number Valve Number Number
Valve 1
Valve 2
Valve 3
Valve 4
Valve 5
Valve 6
22
Hose Hose to to to the the the
Valve Valve Purpose Valve Purpose Purpose
Air line
Flush material
Dump hose
Color 1
Color 2
Color 3
Connect the the CAN CAN Cables
Connect Connect the CAN
Connect the Control Area Network (CAN) cables to
the control interface (42) so that the interface can
communicate with the isolation system.
1. Connect the power supply CAN cable:
a. Locate the CAN cable attached to the power
supply (47) on the back of the cabinet.
b. Screw the cable into the right fitting on the
right side of the cabinet below the light tower.
Figure 15 Controller CAN Cable Connections on
the Cabinet (no Color Change)
Cables
Cables
3A8492A