Graco HydroShield WABH00 Instructions - Parts Manual page 23

2. The system is equipped with another CAN
cable (43) that is used to connect to the control
interface:
On On On systems systems that systems that that are are not are
a. Screw one end of the cable (43) into the
fitting on the right side of the cabinet.
b. The bottom of the controller contains two
fittings. Screw the other end of the cable (43)
into the fitting as shown below.
Figure 16 Connections on the Control Interface
(Systems without Color Change)
On On systems On systems that systems that that are are color are
a. Screw cable (611) into C4 on the color
change module. See the parts figure in
Color Change Components, page 129
Color Change: Pneumatic and Wiring
Connections, page
b. Connect C5 from the color change module to
the control interface.
3. Insert the controller into the bracket (41) on the
top of the cabinet.
3A8492A
not color not color change color change enabled: change enabled: enabled:
color change color change enabled: change enabled: enabled:
and
114.
To mount the controller in another location, remove
bracket (41) from the system and mount it in
a convenient location. For information about
available alternate length CAN cables, see
Accessories, page 126.
Figure 17 Bracket (41) Mounting Holes
Installation
23