Menu Bar; Soft Key Icons; Navigate The Screen - Graco HydroShield WABH00 Instructions - Parts Manual

Menu Bar

Bar
Menu Menu Bar
The menu bar appears at the top of each screen.
Date and and Time: Time: The date and time are always
Date Date and Time:
displayed in one of the following formats.
• DD/MM/YY HH:MM
• MM/DD/YY HH:MM
• YY/MM/DD HH:MM
The time is always displayed as a 24-hour clock.
Set the time in the following Setup menu:
Advanced Screen 1, page
Arrows: The left and right arrows indicate screen
Arrows: Arrows:
navigation.
Screen Menu: Menu: The screen menu indicates the
Screen Screen Menu:
currently active screen, which is highlighted. It also
indicates the associated screens that are available
by scrolling left and right. For example, Home or
Calibrate.
System Mode: System System Mode: The current system mode is displayed Mode:
at the left of the menu bar. There are five modes:
Off, Standby, Prime, Spray, and Purge.
Error Status: Status: If there is an active system error, one of
Error Error Status:
the following icons displays in the middle of the menu
bar: Advisory, Deviation, or Alarm.
If no icon displays, the system has no information
or no error has occurred.
Icon Function
Icon Icon Function Function
Advisory
Deviation
Alarm
3A8492A
55.
Description
Description Description
Informational
Important, no
system shutdown
Very important,
system shutdown
Soft Key Key Icons Icons
Soft Soft Key Icons
NOTICE NOTICE NOTICE
To prevent damage to the soft key buttons, do not
press the buttons with sharp objects such as pens,
plastic cards, or fingernails.
Blue icons indicate that a button is not
available.
Gray icons with a green outline indicate
that the button is active or selected.
Blue icons with a gray outline show that
the button is available, but not active or
selected.
Navigate the the Screen Screen
Navigate Navigate the Screen
To edit the information on a screen press the Enter
Screen key .
To advance to the next screen, press the down arrow
.
Press the Exit Screen button
settings.
To enable a check box, navigate to the box for the
item and press the Enter button
press the Enter button again.
Use the up and down arrows
through the screen.
To reset the cycle count to 0 in the In the Maintenance
screens, press the Count Reset button
second.
Control Interface
to exit the screen
. To clear the box,
to navigate
for one
37