Adjust The Gun Fluid Settings; Shutdown - Graco HydroShield WABH00 Instructions - Parts Manual

Adjust the the Gun Gun Fluid Fluid Settings
Adjust Adjust the Gun Fluid
Preset 0 allows operators to change the gun fluid
pressure at any time. Preset 0 assumes a manual
purge profile.
Use Preset 1 through 99 to configure different
gun fluid pressure settings and a purge profile
number. To set up a purge profile, see
Purge Screens 1–5, page
For example, Preset 1 might use the best pressure
settings for black paint, Preset 02 might use the best
pressure settings for red paint, and Preset 99 might
be set to a higher fluid pressure to perform a quicker
flush.
For instructions on creating presets, see
Presets, page 52. Refer to the gun setup procedure
in your gun manual to select the best gun fluid
settings.
To use To To use use Preset Preset 0 0 0 Preset
Preset 0 can be changed by the operator at any time
during operation.
1. Press the right arrow
on the menu bar.
2. Press the Enter Screen button
screen to edit the current settings.
3. Use the down arrow
field.
4. Press the numbers on the keypad to the desired
psi value.
5. Press the Enter button
The interface automatically advances to the
Preset field.
6. Press the Exit Screen button
screen settings.
Note
If an operator is in Preset 1–99, and then
switches to Preset 0, Preset 0 will reflect the
previous settings.
3A8492A
Settings
Settings
53.
until Home appears
to enter the
to navigate to the Fluid
to register the value.
to exit the
To use use Preset Preset 1 1 1 through through 99:
To To use Preset through
1. Press the right arrow
on the menu bar.
2. Press the Enter Screen button
screen to edit the current settings.
3. Use the up and down arrows
to the Preset field.
4. Enter the Preset number that you would like to
use.
5. Press the Enter button
6. Press the Exit Screen button

Shutdown

Shutdown Shutdown
1. Discharge the system voltage. Follow the
Fluid Voltage Discharge and Grounding
Procedure, page 29.
2. Flush the gun. See
(Systems without Color Change), page 31
Flush the System (Color Change Enabled
Systems), page 32.
3. Follow the Pressure Relief Procedure, page
4. Press the Stop button
interface to change to Off mode.
Operation
99:
99:
until Home appears
to enter the
to navigate
to register the value.
.
Flush the System
or
on the control
30.
35