Graco HydroShield WABH00 Instructions - Parts Manual page 7

ELECTRIC ELECTRIC ELECTRIC SHOCK
This equipment must be grounded. Improper grounding, setup, or usage of the system can
cause electric shock:
• Turn off and disconnect power cord before servicing equipment.
• Connect only to grounded electrical outlets.
• Use only 3-wire extension cords.
• Ensure ground prongs are intact on power and extension cords.
• Do not expose to rain. Store indoors.
• Ground all equipment, personnel, object being sprayed, and conductive objects in or close
to spray area. See Grounding
• All electrical wiring must be done by a qualified electrician and comply with all local codes
and regulations.
• Follow the Fluid
the voltage; before cleaning, flushing, or servicing the system; before approaching the front of
the gun; and before opening the isolation enclosure for the isolated fluid supply.
• Do not touch the gun nozzle or electrode, or come within 4 in. (102 mm) of the electrode
during gun operation. Follow the Fluid
• Do not splice hoses together. Install only one continuous Graco waterborne fluid hose
between the isolated fluid supply and the spray gun.
MOVING MOVING MOVING PARTS
Moving parts can pinch, cut or amputate fingers and other body parts.
• Keep clear of moving parts.
• Do not operate equipment with protective guards or covers removed.
• Equipment can start without warning. Before checking, moving, or servicing equipment,
follow the Pressure
SKIN SKIN INJECTION SKIN INJECTION HAZARD INJECTION
High-pressure fluid from gun, hose leaks, or ruptured components will pierce skin. This may
look like just a cut, but it is a serious injury that can result in amputation. Get
treatment.
treatment. treatment.
• Do not point dispensing device at anyone or at any part of the body.
• Do not put your hand over the fluid outlet.
• Do not stop or deflect leaks with your hand, body, glove, or rag.
• Follow the Pressure
checking, or servicing equipment.
• Tighten all fluid connections before operating the equipment.
• Check hoses and couplings daily. Replace worn or damaged parts immediately.
3A8492A
WARNING WARNING WARNING
SHOCK HAZARD SHOCK HAZARD HAZARD
Grounding Grounding instructions.
Fluid Voltage Voltage Discharge Discharge and
Fluid Voltage Discharge
PARTS HAZARD PARTS HAZARD HAZARD
Pressure Relief Relief Procedure Procedure and disconnect all power sources.
Pressure Relief Procedure
HAZARD HAZARD
Pressure Relief Pressure Relief Procedure Relief Procedure when you stop dispensing and before cleaning, Procedure
and Grounding Grounding Procedure Procedure when instructed to discharge
and Grounding Procedure
Fluid Voltage Fluid Voltage Discharge Voltage Discharge and Discharge and Grounding and Grounding Procedure Grounding Procedure. Procedure
Get immediate Get immediate surgical immediate
Warnings
surgical surgical
7