Graco HydroShield WABH00 Instructions - Parts Manual page 130

Repair Kits and Accessories
Color Color Change Color Change Module Change Module Configuration Module
Configure each module according to its designated
number, as follows:
NOTICE
NOTICE NOTICE
To avoid damaging the circuit boards, wear Part
No. 112190 grounding strap on your wrist and
ground appropriately.
To avoid electrical component damage, remove all
system power before plugging any connectors.
1. Prepare the electrical controls for service. Follow
the steps in Prepare the Electrical Controls for
Service, page 106.
2. Disconnect electrical power from the system.
3. Open the color change module. Locate switches
S4, S5, and S6 on the control module board. The
switches are shipped in the OFF position.
4. For each module, set the switches to ON or OFF,
as shown in the following table.
Non Non- - - IS IS IS Control Non Control Module Control
Control Control Control S6 S6 S6
Module
Module Module
Electronic
Controls
Color
Change
130
Configuration Configuration
Module Switch Module Switch Settings Switch Settings Settings
S5 S5 S5 S4 S4 S4
Replace the Replace Replace the the Color Color Change Color Change Board Change
NOTICE
NOTICE NOTICE
To avoid damaging the circuit boards, wear Part
No. 112190 grounding strap on your wrist and
ground appropriately.
To avoid electrical component damage, remove all
system power before plugging any connectors.
1. Prepare the electrical controls for service. Follow
the steps in Prepare the Electrical Controls for
Service, page 106.
2. Disconnect electrical power from the system.
3. Remove the color change module cover (704).
4. Note where each cable is connected, then
disconnect all cables from the color change
board connectors.
5. Remove the seven mounting screws (703) and
the board (702).
6. Install the new board. Reinstall the screws.
7. Reconnect the cables to the proper connectors,
as noted in step 3.
8. Reinstall the cover (704). Restore electrical
power to the system.
Board Board
3A8492A