Graco HydroShield WABH00 Instructions - Parts Manual page 18

Installation
Connect Connect the Connect the the Fluid Fluid Fluid Hose Hose from Hose
1. Blow the waterborne fluid hose out with air and
flush with flushing fluid to remove contaminants.
2. Connect the Graco waterborne fluid hose to the
gun as described in the spray gun manual. See
the spray gun manual for hose information and
dimensions.
3. Before entering the cabinet:
a. Follow the Fluid Voltage Discharge and
Grounding Procedure, page
b. Follow the
Pressure Relief Procedure, page
c. Open the cabinet. Slide the electrostatic
shield (82) up to remove, and then slide the
electrostatic shield (12) to the left to remove.
4. Loosen the strain relief nut at the hose inlet end
(101c).
5. Slide the other end of the hose through the hole in
the side of the isolated enclosure (CA). Connect
the swivel (101h) to the fluid outlet of the pump.
6. Secure the hose to the side of the enclosure
with the bracket (101j). A bolt (S) assembles
through the hole in the bracket and screws into
the side of the enclosure. Set screw (101m) can
be loosened to rotate the bracket if needed.
18
from the from the Gun the Gun to to to the Gun the Cabinet the
29.
30.
Cabinet Cabinet
7. Tighten the strain relief nut (101c) and set screw
(101m).
Figure 8 Hose Connection at Enclosure
Figure 9 Hose Connection at Enclosure
3A8492A