Table of Contents
Advertisement
To do a 'hard' (device firmware) reboot under emergency conditions (for
example, if the unit malfunctions), do the steps in the following sub- section.
Device firmware reboot
1.
Remove the bottom cover from the main unit enclosure as shown
"Connecting LAN cables to the unit" (page
in
2.
Insert a long tool with a thin shaft, such as a paper clip or a thin
screwdriver, into the RESET button port until the tool touches the
bottom
Figure 8. Cisco FM3500 Endo (Hardware RESET button port)
3.
Press the RESET button for one second, then release the button
immediately.
• The unit will reboot.
Resetting the unit to factory settings
The following methods are available to do a factory reset:
1. To do the reset using the offline Configurator interface, refer to
"Resetting the unit to factory defaults" (page
2. To do the reset using FM Racer, refer to the Fluidmesh Networks
FM Racer User Manual.
3. To do the reset by physically accessing the unit, follow the
procedure below.
To reset the radio to its factory default settings, do the steps that follow:
© 2021 Cisco and/or its affiliates. All rights reserved.
(Figure 8 (page
32)).
CAUTION
Do not do a factory reset unless the unit needs to be
reconfigured using its factory configuration as a starting point.
A factory reset will reset the unit's IP address and administrator
password, and will disconnect the unit from the network.
Hardware installation
36).
138).
Page 32 of 177
Advertisement
Table of Contents
