Table of Contents
Advertisement
Fluidmesh hardware devices are shipped from the factory with L2TP
functionality disabled. To change the unit's L2TP settings, do the following
steps:
1.
Click the -l2tp configuration link under ADVANCED SETTINGS
in the left-hand settings menu.
Figure 47. Configurator GUI (L2TP Configuration dialog)
2.
To enable L2TP functionality for the unit, check the L2TP check-
box.
3.
When the L2TP configuration has been set, save the settings by
clicking the Save button. Alternatively, clear the settings by
clicking the Reset button.
7.7.10. VLAN settings
VLAN configuration
The VLAN SETTINGS window contains controls to connect the Cisco
FM3500 Endo to one or more virtual local area networks (VLANs) that are
part of the local wireless network.
© 2021 Cisco and/or its affiliates. All rights reserved.
Device configuration using the configurator interface
• The L2TP Configuration dialog will be shown
(page
114)).
• The L2TP configuration settings window will be shown.
IMPORTANT
A detailed description of L2TP configuration methods is beyond
the scope of this manual. For detailed instructions on how to set
the L2TP configuration, refer to the Fluidmesh Networks
L2TPv3 Configuration Manual.
IMPORTANT
The VLAN feature must be enabled using a software plug-in
(Fluidmesh part number FM-VLAN). Contact your Fluidmesh
Networks representative for details.
(Figure 47
Page 114 of 177
Advertisement
Table of Contents
