Table of Contents
Advertisement
• The configuration will be applied, and the unit will reboot.
7.8.7. Resetting the unit to factory defaults
The reset factory default window contains controls that allow you to
restore the Cisco FM3500 Endo to its default factory settings (in other
words, to do a 'hard reset').
To reset the unit to its factory defaults, do the following steps:
1.
Click the -reset factory defaults link under MANAGEMENT
SETTINGS in the left-hand settings menu.
• The unit reset dialog will be shown
2.
Reset the unit to its factory defaults by clicking the YES link.
Alternatively, abort the factory reset by clicking the NO link.
• If the YES link was clicked, the unit will do a factory reset,
3.
If you have previously saved a device configuration file for the
unit, you can restore the saved configuration settings to the unit
as shown in
© 2021 Cisco and/or its affiliates. All rights reserved.
Device configuration using the configurator interface
IMPORTANT
Doing a hard reset will revert all unit configuration settings,
including the unit's IP address and administrator password, to
factory defaults.
If you want to reboot the unit instead, refer to
unit" (page 139)
below.
CAUTION
Do not do a hard reset unless the unit needs
to be reconfigured using its factory
configuration as a starting point.
A hard reset will reset the unit's IP address
and administrator password, and will
disconnect the unit from the network.
Figure 62. Configurator GUI (unit reset dialog)
and will reboot.
"Saving and restoring the unit settings" (page
"Rebooting the
(Figure 62 (page
138)).
136).
Page 138 of 177
Advertisement
Table of Contents
