Cisco FM3500 Endo Installation And Configuration Manual page 54

Ultra-reliable wireless backhaul
Hide thumbs Also See for FM3500 Endo:
Table of Contents

Advertisement

Figure 17. FM Racer dialog
• The unit's Local IP address will be set to 169.254.a.b, where a and
b are the last two parts of the unit's unique unit identification (ID)
number. For example, if the unit ID number is 5.12.34.56, the unit's
IP address will be set as 169.254.34.56.
• The unit can also be reached using the DHCP fallback IP address
(192.168.0.10/24).
• The unit's Status and link/boot LEDs will blink continuously from left
to right (green-green-orange-red), then from right to left (red- orange-
green-green). The LEDs will repeat this cycle until the unit either
enters a Fallback condition, or enters Online or Offline mode.
• The unit will attempt to connect to the internet using DHCP.
Make sure that the Cisco FM3500 Endo is connected to a local network that
supports DHCP. If the unit connects successfully to the internet and to the
Partners Portal, the RACER™ Cloud connection info Status will be
shown as Connected
© 2021 Cisco and/or its affiliates. All rights reserved.
Device configuration using the configurator interface
NOTE
DHCP is disabled when the unit leaves Provisioning Mode.
(Figure 18 (page
55)).
Page 54 of 177

Advertisement

Table of Contents
loading

Table of Contents