Table of Contents
Advertisement
• By connecting a control device to the Fluidmesh device through an
internet connection (Internet access)
7.2.1. Local access and login for initial configuration
To use the Configurator interface to access the Cisco FM3500 Endo
directly, do the steps that follow:
1.
Power ON the unit.
2.
Wait approximately one minute for the boot sequence to
complete.
3.
Connect one end of a CAT5/6 Ethernet cable to the computer that
will be used to configure the Cisco FM3500 Endo.
4.
Connect the other end of the Ethernet cable to the Console LAN
port on the Cisco FM3500 Endo.
5.
Manually set the computer's IP address and Netmask to be
recognizable by the Cisco FM3500 Endo. The correct settings are
as follows:
• IP address: 192.168.0.10 (or any other IP address
• Netmask: 255.255.255.0
6.
Launch the computer's web browser.
7.
Enter the IP address of the Cisco FM3500 Endo in the browser's
URL entry field.
• If the Configurator interface is shown immediately, proceed
• Alternatively, you may see the following window:
© 2021 Cisco and/or its affiliates. All rights reserved.
Device configuration using the configurator interface
NOTE
If your computer has a wireless WiFi card, you may have to
disable the card to avoid routing issues between the computer's
wired and wireless network interfaces.
belonging to subnet 192.168.0.0/255.255.255.0)
to
Step 9
below.
Page 49 of 177
Advertisement
Table of Contents
