Table of Contents
Advertisement
Figure 33. Configurator (Advanced Radio Settings menu)
Using the FluidMAX Management Setting
The FluidMAX™ Management controls are used to set the unit's
FluidMAX™ operating mode.
Note that the FluidMAX™ Management controls are only available under
the following conditions:
• If the unit's firmware is equipped with the FluidMAX engine.
• If the unit is currently being operated as part of a point-to-multipoint
network topology.
To use the FluidMAX Management menu, do the following steps:
1.
Click the Radio Mode drop-down menu.
2.
Choose the correct FluidMAX operating mode from the following
list of options:
• AUTO: The FluidMAX engine is enabled, and the unit role
© 2021 Cisco and/or its affiliates. All rights reserved.
Device configuration using the configurator interface
is set automatically. Depending on various factors, the unit
will automatically choose whether to transmit using the
Page 93 of 177
Advertisement
Table of Contents
