Table of Contents
Advertisement
3. Check the round, knurled nuts of the
RPSMA connectors for tightness. If any
round nuts are loose, tighten them by
hand only.
© 2021 Cisco and/or its affiliates. All rights reserved.
Hardware installation
4. Slide a section of Nylon heat-shrinkable tubing
over each unconnected antenna cable.
5. Push the male RPSMA plug of the antenna
cable into the female RPSMA plug of the unit.
6. Screw the threaded sleeve of the male plug
onto the female plug. Tighten the connection by
hand only.
7. Slide the lengths of Nylon heat-shrinkable
tubing over the tightened RPSMA connectors.
8. Use a heat gun to shrink the tubing onto the
connectors.
Page 40 of 177
Advertisement
Table of Contents
