Table of Contents
Advertisement
6. Connect the RJ45 connectors to the
correct LAN ports as shown in
"Connecting LAN cables to the unit"
(page
36).
9. Re-insert and tighten the two screws.
10. Check that the cable gland nut is
properly tightened. If needed, re-tighten
the cable gland nut to the bottom
housing.
11. Press the rubber seal into the cable
gland body. Be careful not to crimp or
damage the Ethernet cables.
12. Install and tighten the hexagon nut.
© 2021 Cisco and/or its affiliates. All rights reserved.
Hardware installation
7. Place the bottom housing securely against the
main body of the radio.
Page 37 of 177
Advertisement
Table of Contents
