Table of Contents
Advertisement
7.
Upload the firmware image file to the unit by clicking the Choose
File button and following the software prompts.
• The Upgrade button will become available.
8.
Click the Upgrade button. Follow the software prompts until the
firmware overwrite is complete.
• When the overwrite is complete, the unit will automatically
If the previous firmware was overwritten with a newer version of firmware,
check that the firmware upgraded correctly by doing the following steps:
•
When the overwrite is complete, make sure that the upgraded
firmware has a greater version number than the firmware that
was previously installed.
• If the firmware version has not changed, the firmware
7.8.4. Plug-In management
The MANAGE PLUG-INS page shows which software plug-ins are currently
active on the unit, and contains controls that allow you to do the following
functions:
• Upload activation codes that allow the unit's accessory software plug-
ins to function.
• Activate uploaded software plug-ins for use with the unit.
© 2021 Cisco and/or its affiliates. All rights reserved.
Device configuration using the configurator interface
Figure 56. Configurator GUI (typical FIRMWARE
UPGRADE dialog)
reboot.
upgrade has failed. Repeat the overwrite from step
above.
IMPORTANT
For a complete list of software plug-ins that are currently
available for the Cisco FM3500 Endo, refer to
ins" (page
142).
Step 1
"Available plug-
Page 130 of 177
Advertisement
Table of Contents
