Table of Contents
Advertisement
Figure 38. Configurator (Pass list / Block list dialog)
• The Pass list / Block list dialog will be shown
2.
Choose the type of list to be uploaded by clicking the correct List
Type: radio button.
3.
Click the Choose File button. Upload the saved *.CSV file using
the upload dialog.
• The contents of the uploaded *.CSV file will be shown in
To apply the list settings contained in the *.CSV file, click the Apply
Settings button.
To clear the Pass list or Block list settings without deleting the *.CSV file,
click the Clear Pass list or Block list button.
To delete the Pass list or Block list *.CSV file, click the Reset button.
7.7.5. Multicast
Multicast management for mesh network-capable devices
Multicast is a group-communication method in which data transmissions are
addressed simultaneously to more than one destination computer. Multicast
transmissions can be point-to-multipoint, or multipoint-to- multipoint.
By default, if CCTV cameras and devices that operate in a similar fashion
are linked to a Fluidmesh transceiver unit operating in Mesh Point mode,
the unit forwards all multicast traffic generated by the cameras to the closest
Mesh End unit in the wireless network.
© 2021 Cisco and/or its affiliates. All rights reserved.
Device configuration using the configurator interface
(page
101)).
the Pass list / Block list Status section.
(Figure 38
Page 101 of 177
Advertisement
Table of Contents
