Using The Max Tx Power Setting - Cisco FM3500 Endo Installation And Configuration Manual

Ultra-reliable wireless backhaul
Hide thumbs Also See for FM3500 Endo:
Table of Contents

Advertisement

• principal: The unit will be set as the center unit within a
• SUBORDINATE: The unit will be set as a subordinate unit
• OFF: The FluidMAX engine will be disabled.
3.
If the operating mode is set to principal or SUBORDINATE, enter
a unique cluster ID tag in the FluidMAX Cluster ID field.
4.
If the operating mode is set to SUBORDINATE, check the
FluidMAX Autoscan check-box to allow the principal unit of the
local mesh cluster to dictate the frequency on which the unit will
transmit and receive.
5.
If the FluidMAX Autoscan check-box is checked, the Include
5-10 MHz Channels in Autoscan check-box will become
available. Check this check-box to increase the scan resolution
from the default of 20, 40 or 80 MHz to 5-10 MHz.
6.
Click the Save button to save your settings. Alternatively, clear
the settings by clicking the Cancel button.

Using the Max TX Power setting

This setting controls the effective isotropic radiated power (EIRP) output of
the unit. By default, EIRP is automatically regulated using Fluidmesh's
Transmission Power Control (TPC) algorithm. The algorithm tries to obtain
an optimal link signal strength of approximately -55 dBm on both sides of
the radio link while not exceeding the user-defined maximum transmission
power threshold.
© 2021 Cisco and/or its affiliates. All rights reserved.
Device configuration using the configurator interface
time-division multiple access (TDMA) protocol or the
carrier-sense multiple access (CSMA) protocol.
mesh cluster featuring a 'star' topology. If the unit is set as
a principal, it will dictate the operating frequency of the
mesh cluster of which it is a principal unit.
within a mesh cluster featuring a 'star' topology. If the unit
is set as a Subordinate, and its Autoscan feature is
enabled, the unit will scan the spectrum of available
frequencies for a principal unit that shares its Cluster ID,
and its frequency selection feature will be disabled.
NOTE
Under normal circumstances, leave the Include 5-10
MHz Channels in Autoscan check-box unchecked.
Page 94 of 177

Advertisement

Table of Contents
loading

Table of Contents