Table of Contents
Advertisement
Rebooting the unit
The reboot window contains controls that allow you to reboot the Cisco
FM3500 Endo (in other words, to re-start the unit's operating system).
To reboot the unit, do the following steps:
1.
Click the -reboot link under MANAGEMENT SETTINGS in the
left-hand settings menu.
• The unit reboot dialog will be shown
2.
Reboot the unit by clicking the YES link. Alternatively, abort the
reboot by clicking the NO link.
• If the YES link was clicked, the unit will reboot.
7.8.8. Logging out
If clicked, the logout option logs the current user off the unit, and out of the
Configurator interface.
•
To log out, click the -logout link under MANAGEMENT
SETTINGS in the left-hand settings menu.
• You will be logged off the unit and out of the Configurator
• The web browser will show the Authentication Required
© 2021 Cisco and/or its affiliates. All rights reserved.
Device configuration using the configurator interface
139)).
Figure 63. Configurator GUI (unit reboot dialog)
interface with no further prompting.
dialog
(Figure 64 (page
log in again.
Figure 64. Web browser (Authentication Required
dialog)
(Figure 63 (page
139)). If needed, use the dialog to
Page 139 of 177
Advertisement
Table of Contents
