Table of Contents
Advertisement
The FLUIDITY window contains controls to change the unit's Fluidity
settings. To change the settings, do the following steps:
1.
Click the -Fluidity™ link under ADVANCED SETTINGS in the
left-hand settings menu.
• The FLUIDITY dialog will be shown
2.
Fluidmesh radio transceivers are shipped from the factory with
Fluidity functionality disabled. Enable Fluidity functionality by
checking the Fluidity check-box.
3.
Select the correct role for the unit by clicking the Unit Role: drop-
down and clicking the correct option from the list below:
• Infrastructure: Choose this setting if the unit is connected
© 2021 Cisco and/or its affiliates. All rights reserved.
Device configuration using the configurator interface
Figure 49. Configurator GUI (FLUIDITY dialog for
transceiver devices)
to a wired LAN and/or a network that includes other
Infrastructure nodes, and the unit acts as the network
infrastructure entry point for mobile vehicles.
(Figure 49 (page
118)).
Page 118 of 177
Advertisement
Table of Contents
