Table of Contents
Advertisement
FM Monitor is used to:
• Monitor the real-time condition of Fluidmesh-based networks.
• Generate statistics from network history.
• Verify that device configuration settings are optimal for current
network conditions.
• Detect network-related events for diagnostic and repair purposes,
and generate alerts if network-related faults arise.
• Analyse network data with the goal of increasing system uptime and
maintaining optimum network performance.
• Generate and back up network statistics databases for future
reference.
To view and access the FM Monitor settings, do the steps that follow:
1.
Log in to the Configurator interface as shown in
the Cisco FM3500 Endo for device configuration" (page
Click the MONITOR™ link in the left-hand settings menu.
2.
• The MONITOR™ landing page will be shown (below).
© 2021 Cisco and/or its affiliates. All rights reserved.
Device configuration using the configurator interface
IMPORTANT
FM Monitor cannot be used to configure Fluidmesh gateway
and radio transceiver devices. Fluidmesh devices can be
configured using any of the following methods:
You can apply a pre-created Cloud-based configuration,
or do manual configuration of a device, using the FM
Racer interface. For instructions on how to use the FM
Racer interface, refer to the Cisco FM Racer
Configuration Manual.
You can manually configure a device by using the
device's built-in Configurator interface. For instructions
on how to use the Configurator interface, refer to the
relevant section of this manual.
You can do command-line-based manual configuration
of a device by using the device's built-in CLI interface.
For instructions on how to use the CLI interface, refer to
the Fluidmesh Command-line interface user manual.
"Accessing
48).
Page 61 of 177
Advertisement
Table of Contents
