Table of Contents
Advertisement
2.
Enable NTP synchronization by checking the Enable NTP check-
box.
3.
Enter the host name of a chosen primary NTP server in the NTP
server hostname: field.
4.
If needed, enter the host name of a chosen secondary NTP
server in the Secondary NTP server (optional): field.
5.
Select the time zone in which the unit is installed by clicking
the Select Timezone: drop-down menu and clicking the correct
time zone option.
6.
Save the NTP settings by clicking the Save button. Alternatively,
clear the settings by clicking the Reset button.
7.7.9. L2TP configuration
Layer 2 Tunneling Protocol (L2TP) functionality allows Fluidmesh radio
transceivers to support integration with virtual private networks (VPNs).
© 2021 Cisco and/or its affiliates. All rights reserved.
Device configuration using the configurator interface
Figure 46. Configurator GUI (NTP dialog)
IMPORTANT
The NTP server host names shown in
(page 113)
are for reference purposes only. Your
company policy may dictate that you use one or more
specific time servers.
IMPORTANT
The L2TP configuration option is only available if the Cisco
FM3500 Endo is set to Mesh Point mode or Mesh End mode.
If the unit is set to Bridge mode, the -l2tp configuration menu
option will not be available.
The L2TP feature must be enabled using a software plug-in
(Fluidmesh part number FM-L2TP). Contact your Fluidmesh
Networks representative for details.
Figure 46
Page 113 of 177
Advertisement
Table of Contents
