• The LAN1/POE connection (right-most connector) is an 8-pin M12X
port, designed to connect the unit to a local area network (LAN)
switch and/or to an IEEE 802.3 48 Vdc power source.
5.1.4. Rebooting the firmware and resetting the unit to factory
defaults
The Cisco FM4500 Mobi hardware can be rebooted and reset to factory
default condition using the procedures in this section.
IMPORTANT
The following procedure shows how to do a 'hard' (device
firmware) reboot. To do a 'soft' (device software) reboot, refer
to
To do a 'hard' (device firmware) reboot under emergency conditions (for
example, if the unit malfunctions), do the steps in the following sub-
section.
Device firmware reboot
•
Press the RESET button on the bottom cover of the unit
(page
30)) for one second, then release the button immediately.
Figure 7. Cisco FM4500 Mobi (Hardware RESET button)
• The unit will reboot.
© 2021 Cisco and/or its affiliates. All rights reserved.
IMPORTANT
The Cisco FM4500 Mobi can accept power from a
power source conforming to IEEE 802.3at ONLY.
"Resetting the unit to factory defaults" (page
Hardware installation
138).
(Figure 7
Page 30 of 174