Table of Contents
Advertisement
The default IP address for all Fluidmesh devices is 192.168.0.10 /
255.255.255.0.
You can configure any Ethernet device manually or automatically, using a
DHCP server that resides on the LAN network. The Fluidmesh network is
totally transparent to DHCP, therefore, DHCP requests and responses can
be forwarded transparently across the network.
Fluidmesh radio transceivers
A wide variety of Ethernet edge devices, such as IP cameras and Wi-Fi
access points, can be connected to the Ethernet ports of the Cisco FM3500
Endo. You can configure any Ethernet device manually or automatically by
using a DHCP server that resides on the LAN network.
The Fluidmesh network is totally transparent to DHCP. Therefore, DHCP
requests and responses can be forwarded transparently across the
network.
© 2021 Cisco and/or its affiliates. All rights reserved.
IMPORTANT
If an Ethernet-based system using multiple peripheral
components is connected to the wireless network, assign each
peripheral component a fixed IP address. If dynamic IP
addressing is used, the components may not be accessible to
third-party software that relies on the components for data
input.
A typical example is a video surveillance system equipped with
multiple CCTV cameras. Each camera must be assigned a
fixed IP address to be accessible to the video-recording
software.
IMPORTANT
If a video surveillance system is connected to the wireless
network, assign each camera a fixed IP address. If dynamic IP
addressing is used, the cameras may not be accessible to the
video-recording software.
Getting Started
Page 22 of 177
Advertisement
Table of Contents
