To use the Max TX Power setting, do the following steps:
1.
Click the Select TX Max Power: drop-down menu.
2.
Choose the correct transmission power level from the following
list of options:
• Transmission power can be manually adjusted from -3
• If you select the AUTO option, the unit will automatically
3.
Click the Save button to save your settings. Alternatively, clear
the settings by clicking the Cancel button.
Using the Select Antenna Gain setting
This setting controls the maximum antenna gain in dBm. By default,
antenna gain is not pre-set at the factory.
To use the Select Antenna Gain setting, do the following steps:
1.
Click the Select Antenna Gain: drop-down menu.
2.
Choose the correct antenna gain level. Gain can be manually
adjusted from 0 dBm to 36 dBm.
3.
Click the Save button to save your settings. Alternatively, clear
the settings by clicking the Cancel button.
Using the Data Packet Encryption setting
This setting controls whether Advanced Encryption Standard (AES)
encryption is applied to outgoing data packets.
© 2021 Cisco and/or its affiliates. All rights reserved.
Device configuration using the configurator interface
NOTE
if Max TX Power is set to AUTO, the maximum transmission
power may vary at any moment depending on the operating
frequency of the unit, atmospheric conditions, and other factors.
If the unit's country selection is set to any country within Europe,
TPC is automatically enabled.
dBm to 24 dBm.
choose the most efficient transmission power level
according to prevailing conditions. However, the unit will
not exceed the last manually selected Max TX Power
parameter.
IMPORTANT
The Data Packet Encryption setting must be the same on all
Fluidmesh units that are part of the same network.
Page 95 of 177