Save the LAN settings by clicking the Save button. Alternatively, clear the
settings by clicking the Reset button.
7.5.2. Wireless settings
Modifying the wireless settings
The WIRELESS RADIO window contains controls to change the following
settings:
• The shared network passphrase.
• The national territory in which the wireless network is installed.
• The operational radio frequency and bandwidth settings.
To change the Wireless Settings, do the following steps:
1.
Click the -wireless radio link under GENERAL SETTINGS in the
left-hand settings menu.
• The WIRELESS RADIO dialog will be shown
2.
Enter a defined network passphrase in the Shared Passphrase
field.
© 2021 Cisco and/or its affiliates. All rights reserved.
Device configuration using the configurator interface
IMPORTANT
If the Cisco FM3500 Endo was purchased in the USA or
Canada, the Country selection is set to the country of purchase,
and the Country: drop-down will be disabled.
(page
67)).
Figure 26. Configurator GUI (Wireless Radio dialog)
(Figure 26
Page 67 of 177