Table of Contents
Advertisement
If the unit cannot connect to the internet in Provisioning Mode, try to
connect to the internet by doing the following steps:
1.
Enter alternative Local IP, Local Netmask, Default Gateway,
Local Dns 1 and Local Dns 2 values as needed, using the
RACER™ dialog.
2.
Click the Save fallback IP button
• The web browser will show the unit reboot dialog
3.
Click the OK button to proceed, or click the Reset button to go
back to the RACER™ dialog and adjust the settings.
• If you click the OK button, the unit will reboot, but will
• The unit will attempt to connect to the internet using the
If the unit cannot connect to the internet using the DHCP fall-back
configuration settings, the RACER™ Cloud connection info Status will
be shown as Disconnected
Figure 20. RACER™ Cloud connection info status (Disconnected)
Configure the unit by doing the following steps:
1.
Click the Reset to Provisioning button at the bottom of the
DHCP fall-back configuration section.
© 2021 Cisco and/or its affiliates. All rights reserved.
Device configuration using the configurator interface
(Figure 19 (page
56)).
Figure 19. Unit reboot dialog (typical)
remain in Provisioning Mode.
new connection values.
(Figure 20 (page
(Figure 17 (page
54)).
56)).
Page 56 of 177
Advertisement
Table of Contents
