Table of Contents
Advertisement
• Save the unit's existing software configuration as a configuration
(*.CONF) file.
• Upload and apply a saved configuration file to the current unit.
To download the unit's existing configuration settings to your computer, do
the following steps:
1.
Click the -configuration settings link under MANAGEMENT
SETTINGS in the left-hand settings menu.
• The LOAD OR RESTORE SETTINGS dialog will be shown
2.
Download the unit's configuration (*.CONF) file to your computer
by clicking the Save button and following the software prompts.
To upload a saved configuration file to the Fluidmesh unit, do the following
steps:
1.
Find the configuration (*.CONF) file that must be uploaded to the
unit by clicking the Browse... button and following the software
prompts.
• The name of the configuration file to be uploaded will be
2.
Apply the configuration settings to the unit by clicking the
Restore button.
© 2021 Cisco and/or its affiliates. All rights reserved.
Device configuration using the configurator interface
TIP
Saved configuration files can be copied and distributed
for use on more than one Fluidmesh unit of the same
type, simplifying the configuration of other deployed
units.
Saved configuration files can also be used for
configuration backup. This can greatly speed up re-
deployment if a damaged unit must be replaced with a
unit of the same type.
(Figure 61 (page
137)).
Figure 61. Configurator GUI (LOAD OR RESTORE
SETTINGS dialog)
shown to the right of the Browse... button.
Page 137 of 177
Advertisement
Table of Contents
